Skip to content
Port Colborne Plumber

FAQ

Frequently asked questions

If your question is not here, ask us directly.

A plumber answering a homeowner's last question on the front path

Drains and sewers

My house is in Humberstone or near Tennessee Avenue. Why do the drains keep blocking?

Port Colborne's oldest houses, from the Gravelly Bay settlement to the old Village of Humberstone, usually still have cast iron drain stacks and a clay sewer lateral under the lawn. Roots get into the clay joints, and cast iron scales up from the inside. If one sink is slow, the trouble is usually close to that sink. If the basement floor drain is the slow one, or several fixtures slow down together, the lateral is the more likely cause. Note which drains are slow and since when, and ask for a camera look at the line when you book drain cleaning.

Which part of the sewer line does a Port Colborne homeowner own?

The City of Port Colborne looks after its sanitary sewer mains and the service from the main to the property line. Everything from the property line to your house, including the lateral under the lawn and the drains inside, is the owner's to maintain and repair. The water line is split at the same place. If a drain backs up, start inside: check whether one fixture or the whole house is affected before calling anyone. Who pays when a tenant is involved is covered in Who is responsible for a blocked drain or sewer line: tenant, landlord, homeowner or the City?

Where should a backwater valve be installed?

On the building drain, inside the house, where it can protect the fixtures that sit lowest. Ontario's Building Code (Article 7.4.6.4.) requires one in new work where drains may be subject to backflow, such as fixtures below the level of the street or below the upstream sanitary manhole cover. It has to stay reachable so the flap can be checked and cleaned. Look for a clear access cover in the basement floor near the front wall, then read Does your house have a backwater valve? How to find it, where it belongs and what it means for your insurance.

Water and water heaters

A pipe froze overnight in my Port Colborne house. What should I do first?

Open the tap on that line so water has somewhere to go as it thaws. If you see a split or water on the floor, shut the main valve first. Warm the pipe slowly with a hair dryer, or a space heater kept well back, and never with an open flame. Port Colborne averages about 121 days a year at or below 0 °C and about 23 below -10 °C, so lines along outside walls, in crawl spaces and in garages are the usual ones to freeze. Find and test your main shut-off before the next cold snap, then read How to keep pipes from freezing in a Port Colborne winter, and what to do if one does.

Could my older Port Colborne house have a lead water line?

It could. Port Colborne's water is drawn from the Welland Canal, treated by Niagara Region and delivered by the City, and the City notes that many older private water lines may contain lead. Ontario's drinking water standard for lead is 0.010 milligrams per litre. Look at the pipe where it comes through the basement wall, before the meter. Lead is dull grey and soft enough to scratch shiny with a key, and a magnet will not stick to it. If that is what you see, ask the City about its private service line grant, then read about replacing your side of the line under plumbing repairs.

Why does the water from my taps look rusty in an older Port Colborne house?

Port Colborne's water arrives treated, so the colour usually comes from the pipe inside the house. Houses built before 1945 often started with galvanized steel water lines, which rust from the inside as they age. If only the hot water is brown, the water heater tank is the more likely cause. If the water is brown everywhere, including at the meter, there may be work on the City's main. Run the cold tap nearest the meter for a minute and compare it with a tap upstairs, then read about replacing corroded pipe under plumbing repairs.

Maintenance

Does the City of Port Colborne help pay for backflow protection?

Yes, subject to available budget. Residential owners who receive a City water and wastewater bill can apply for a grant towards disconnecting weeping tile, downspouts and sump pump connections from the wastewater system, and towards installing a sewage backflow prevention device. Post-war houses, such as those along Barrick Road and around Olga Drive, often have weeping tile tied into the sanitary sewer, which is where this helps most. The work must be approved before it starts, so apply to the City first and book nothing until you have approval. Then read about sewer repair and backwater valves.

What keeps a sump pump reliable through a Port Colborne storm?

How it is looked after matters more than its make. Port Colborne gets about five days a year with 25 mm of rain or more, and the newer houses in areas such as Westwood Estates and Mapleview depend on the sump pump to keep the foundation dry. Before the season, pour a pail of water into the pit and watch the pump start, empty the pit and stop. Check that the discharge pipe outside is clear and runs away from the house. A battery backup keeps the pit emptying during a power cut. Test yours this fall and read about sump pumps.

Emergencies and safety

Who can install or service a gas water heater in Port Colborne?

In Ontario, fuel-fired appliances such as gas water heaters must be installed and serviced by a registered contractor using qualified gas technicians, under Ontario Regulation 212/01 (Gaseous Fuels). That covers replacing the heater, moving it and working on the gas line or venting. Gas work is performed by TSSA-certified gas technicians. If you smell gas near the heater, leave the house first and call your gas utility from outside. For anything else, such as no hot water or a leak at the base, note what the heater is doing and read about water heaters.

General

When does plumbing work on a Port Colborne house need a building permit?

Under Ontario's Building Code Act, 1992, installing, extending or materially altering or repairing plumbing generally needs a permit, so new fixtures and changes to drains usually do. The work must meet Part 7 of Ontario's Building Code, Ontario Regulation 163/24. Plumbing is a compulsory trade in Ontario: the person doing it must hold a Certificate of Qualification or a provisional certificate, or be a registered apprentice, and appear on the Skilled Trades Ontario Public Register. Work is performed by licensed plumbers (306A Certificate of Qualification). Before work that changes your drains, ask the City of Port Colborne building department whether a permit applies, and see plumbing repairs.

What decides what a plumbing repair will cost?

Mostly what the problem turns out to be and how much of the pipe it involves. A blocked trap or a worn valve is a short job. A cracked clay lateral under the lawn means digging, a locate request and often a permit. The age of the house, how easy the pipe is to reach and the parts involved also count. The plumber looks first and explains what is wrong, and you see the price in writing and approve it before anything is fitted. Describe what the water is doing on the quote page.

Still have a question?