A pipe has burst or is spraying: what do you do first?
Shut the main water valve. In most Port Colborne houses it is in the basement, where the water line comes through the front foundation wall, near the meter. Turn it clockwise until it stops. Then open the lowest cold tap in the house so the water left in the pipes drains out there and not through the ceiling. If the burst is on a hot line, also close the cold supply valve on top of the water heater.
Next, think about electricity. If water is near an outlet, a light fitting or the electrical panel, do not reach for anything while you are standing in water. If you can get to the breaker panel from a dry floor, switch off the circuit for that area. If you cannot, stay out of the room and tell us when you call. Once you are safe, move what you can off the floor and take photos for your insurer.
If the main valve will not turn, do not force it with a wrench until something breaks. Tell the person who answers. The City looks after the water line from the main to the property line, so the City is the one to ask about shutting the water off at the street.
Water is coming up through the basement floor drain: is it the sewer?
Usually, yes. The safe thing to do right away is to stop using water anywhere in the house: no flushing, no laundry, no dishwasher, no showers. Everything drains into the same pipe, so anything that goes down a sink upstairs can come up in the basement. Treat the water as sewage. Keep children and pets out, and do not walk through it without boots and gloves.
Why it happens depends on the house. In the older houses on Tennessee Avenue and in Humberstone, the basement floor drain often runs straight to the sewer and there is no sump pump, so when the sewer fills in a downpour the water comes up through the lowest opening. In the post-war houses along Barrick Road and around Olga Drive, the foundation weeping tile is often tied into the sanitary sewer, which sends rainwater into a pipe that was not built for it. Environment Canada's 1981-2010 normals for Port Colborne show about five days a year with 25 mm of rain or more, and those are the days these drains back up. If it is dry outside and only your house is affected, the cause is more likely roots or a break in your own sewer line under the lawn.
Once the water is down, the next step can wait for a calm day. The owner is responsible for the sewer service from the property line to the house, and a camera look shows what state that part is in. The City of Port Colborne also offers a grant, subject to its budget, towards a backflow prevention device and towards disconnecting weeping tile and downspouts from the sewer. The work has to be approved before it starts. See sewer repair and backwater valves for how that works.
A pipe has frozen: what is safe to try?
Port Colborne has a long frost season. Environment Canada's 1981-2010 normals show about 121 days a year at or below 0 °C and about 23 days below -10 °C, with frost on average from around October 26 to around April 25. The pipes that freeze are usually on an outside wall, in a crawl space, next to an outdoor tap or running through an unheated porch or garage.
If a tap gives only a trickle or nothing at all, open it and leave it open so water can move as the pipe thaws. Warm the area gently. Open the cabinet doors under the sink, turn the heat up, and use a hair dryer on the pipe, starting at the tap end and working back towards the cold spot. Never use an open flame or a torch. Frozen pipes often split, and a split only leaks once the ice melts, so keep an eye on the pipe as it warms and know where your main valve is.
Call if you cannot reach the frozen section, if there is no water anywhere in the house, which can mean the service line itself has frozen, or if the pipe has split. Our guide on keeping pipes from freezing in a Port Colborne winter covers how to stop it happening again.
An overflowing toilet or a steady leak: does it need a plumber tonight?
For a toilet, turn the small valve behind it clockwise to stop it filling. If the valve will not move, lift the tank lid and hold the float up. Do not flush again. If only that one toilet is blocked and the other drains work normally, the clog is local and it can often wait until morning. If the toilet rises when the washer empties, or other drains gurgle or back up as well, the main line is blocked. Treat that the same way as water at the floor drain.
Plenty of things can wait. A dripping tap, a running toilet or a slow sink can wait for an ordinary visit for plumbing repairs or drain cleaning. A leak you can stop by closing the valve under the fixture can usually wait too. What should not wait is water you cannot stop, sewage in the basement, no water in the house in winter, water near electrical equipment, or a sump pump that has stopped during a storm. That last one is the usual problem in newer subdivisions such as Westwood Estates and Mapleview, where the house depends on the pump.
What happens when you call Port Colborne Plumber?
A person answers and takes the details: what the water is doing, what you have already shut off and roughly how old the house is. A plumber then calls you back, tells you whether it is safe to leave things as they are and what to do in the meantime, and arranges the visit.
At the house, the plumber's first job is to make things safe: stop the water, clear the line or get the pump running. Then they find the cause and explain it in plain words. You approve a written price before any part is fitted. Work is performed by licensed plumbers (306A Certificate of Qualification).
The emergency fix and the lasting fix are often different things. A clamp will hold a split copper line overnight, and a cleared sewer drains today, but roots grow back. We tell you which is which, so the lasting repair can be planned when nobody is standing in water.
