Skip to content
Port Colborne Plumber

Sewer lines and backflow protection

Sewer repair and backwater valves in Port Colborne

When the floor drain backs up or the lowest toilet gurgles after rain, the cause is usually the sewer line under your lawn. Port Colborne Plumber looks with a camera first, shows you the footage, explains which part of the line is yours and fits a backwater valve where it makes sense.

A camera look first, then a plain answer on which pipe is yours.

Is sewage coming up through the floor drain right now?

Stop using water in the house first. Every flush, shower and load in the washer goes down the same line and comes back up at the lowest opening, which is usually the basement floor drain. Tell everyone at home, and switch off the washer or dishwasher if either is running.

Keep clear of the water itself, since sewage carries bacteria. If it is near an outlet, the furnace or a freezer, turn off that circuit at the panel, but only if you can reach the panel without stepping through water. Take photos for your insurer before you move or throw anything out, then call for an emergency visit.

If the backup has stopped rising and is going down slowly, you can leave it until the plumber arrives. If water keeps coming up while nobody in the house is using any, the City sewer is usually full from heavy rain, and the plumber will explain what that means for your line once it has gone down.

What are the signs of a sewer line that is starting to fail?

The early signs are quieter than a backup: the lowest toilet gurgles when the washer drains, the floor drain smells of sewer or drains slowly, several fixtures slow down at once, or a blockage comes back every few months however often it is cleared. Sometimes there is a soft or unusually green strip of lawn over the line.

One slow sink is a local blockage, and drain cleaning is the right call. Several slow fixtures, or the lowest drain in the house backing up, point to the main line. That should be looked at soon, but if the water is going down and nothing has come up, it can wait for a booked visit rather than an emergency call.

What is usually wrong with the sewer line in a Port Colborne house?

It depends on when the house was built. In the oldest parts of town, such as the vacation homes from 1888 that still stand on Tennessee Avenue and the former Village of Humberstone, the sewer is usually the original clay lateral, and the basement floor drain runs straight into it. Roots get in at the clay joints, old sections sag or collapse, and with no backflow protection a full sewer has an open path into the basement.

The post-war houses along Barrick Road and around Olga Drive usually have clay or fibre laterals, which roots also find, and their foundation weeping tile is often tied into the sanitary sewer. In a downpour, the water from around the foundation and the water from the street end up in the same pipe. Port Colborne sees about five days a year with 25 mm of rain or more, and those are the days these basements tend to back up.

In the newer subdivisions, such as Westwood Estates, Rosedale Estates, Mapleview and Millar's Crossing, the lateral is plastic and the foundation drains to a sump pump, often with a backwater valve already on the sewer. The pipe is rarely the problem in these houses; more often it is a valve that has never been opened and cleaned.

Which part of the sewer line is yours to repair?

The City of Port Colborne is responsible for the sewer from the main to the property line. The section from the property line to your house belongs to you, and so does the repair if that is where the fault is. The camera measures how far along the line a fault sits, so you can see which side of the line it is on. If it turns out to be on the City side, we show you the footage so you can report it to the City.

The City also offers grants to owners of existing homes towards replacing the private water and sewer lines, and notes that many older lines may contain lead. If your water line is as old as your sewer, it is worth asking about both together. See plumbing repairs for the water side, and our guide on who is responsible for a blocked drain or sewer line if you rent or rent out the house.

How does a camera inspection and sewer repair go?

The plumber finds the cleanout, usually near where the drain leaves the basement wall, and clears the line first if it is blocked. Then the camera goes down the line on a cable with a distance counter. You watch the footage with the plumber, who explains what the roots, cracks, sags or offset joints mean. If a repair looks likely, the camera head is traced from the surface to mark where the fault is and how deep it lies.

Public locates do not mark your own sewer, which is why the tracing is needed. Before any digging, a locate is requested through Ontario Dig Authority to mark the gas, hydro and other buried utilities, and the request costs nothing. A single broken joint or a root-filled section can often be dug up and replaced on its own. A line that is cracked or sagging along most of its length is usually better replaced from the house to the property line. New drains and changes to drains generally need a building permit, and the City's building department decides whether a given job does.

You get a written price for the repair before any digging starts. Work is performed by licensed plumbers (306A Certificate of Qualification).

Do you need a backwater valve, and can the City grant help?

A backwater valve sits on the main drain inside the house. It lets water flow out as normal and closes when the sewer pushes water back, so the floor drain stays dry when the street sewer is full. Ontario's Building Code (Part 7, Article 7.4.6.4.) requires one in construction where fixtures sit below the level of the adjoining street, or below the upstream sanitary manhole cover in a house served by a public sanitary sewer. Many older Port Colborne basements were built long before that rule.

The City of Port Colborne offers residential owners who receive a water and wastewater bill a grant towards installing a sewage backflow prevention device and towards disconnecting weeping tile, downspouts and sump pump connections from the wastewater system. It depends on available budget, and the work has to be approved before it starts, so apply first and book the work after. If your weeping tile is still tied into the sewer, a valve on its own can leave that foundation water nowhere to go when it closes, which is why disconnection and a sump pump often belong in the same plan.

Once it is in, a valve needs a look once or twice a year: take off the cover, check that the flap moves freely and clear out any debris. If you are not sure whether your house already has one, our guide on finding a backwater valve and what it means for your insurance walks you through it.

Our commitments

What can you count on when you call?

  • Licensed and insured

    Every plumber holds a current 306A Certificate of Qualification and is covered by liability insurance. Your home is protected on every job.

  • Every call is answered

    Day or night, a person or our receptionist answers, takes the details and a plumber calls you back.

  • Written price before work starts

    You see the number and approve it before any part is fitted. No surprises on the invoice.

  • 1-year workmanship warranty

    All labour comes backed by a one-year warranty. If a repair we made fails within the warranty period, we return and fix it at no additional labour cost.

Questions about sewer repair

Which part of the sewer line does a Port Colborne homeowner own?

The City of Port Colborne looks after its sanitary sewer mains and the service from the main to the property line. Everything from the property line to your house, including the lateral under the lawn and the drains inside, is the owner's to maintain and repair. The water line is split at the same place. If a drain backs up, start inside: check whether one fixture or the whole house is affected before calling anyone. Who pays when a tenant is involved is covered in Who is responsible for a blocked drain or sewer line: tenant, landlord, homeowner or the City?

Where should a backwater valve be installed?

On the building drain, inside the house, where it can protect the fixtures that sit lowest. Ontario's Building Code (Article 7.4.6.4.) requires one in new work where drains may be subject to backflow, such as fixtures below the level of the street or below the upstream sanitary manhole cover. It has to stay reachable so the flap can be checked and cleaned. Look for a clear access cover in the basement floor near the front wall, then read Does your house have a backwater valve? How to find it, where it belongs and what it means for your insurance.

All questions

Is water somewhere it should not be?

Tell us what you see, by phone or with the form. A plumber calls you back and gives you a written price before any work starts.