Is water coming up through the basement floor drain?
If water is rising from the floor drain, first stop using water anywhere in the house. Don't flush, don't run the washer or dishwasher, and don't shower. Water poured down a sink upstairs ends up at the lowest opening in the house, which is that floor drain. If water is near the furnace, an outlet or a power bar, stay away from it. Only switch off the breaker for that area if you can reach the panel without stepping in water.
Then look at what is coming up. Clear water after a long downpour usually means the sewer is overloaded with rain or groundwater. Grey or brown water with a smell is sewage, so keep children and pets out of the basement until it has been cleaned up. Either way, a floor drain that is backing up means the problem is in the main line, and this is the drain problem that should not wait. Our emergency plumber page explains what happens when you call.
Why is only one sink or tub slow?
When just one fixture drains slowly, the blockage is almost always close to that fixture. Kitchen sinks collect grease that cools and hardens in the trap and in the pipe behind the wall. Bathroom sinks and tubs collect hair held together by soap. A toilet that keeps blocking may have something stuck in the bend: a plunger moves it but doesn't get it out.
This can usually wait for a booked visit. Use the other fixtures and keep water out of the slow one. If it's the toilet, it's safe to try a plunger with a flange. But if two or more fixtures slow down together, or a toilet gurgles when the washer drains, the blockage is further along, in a pipe the fixtures share. That needs a different approach, covered below.
What does the age of a Port Colborne house say about its drains?
The oldest houses in town, such as the ones on Tennessee Avenue and in the former Village of Humberstone, usually have a cast iron drain stack and a clay sewer pipe under the lawn. Over the years cast iron gets rough and scaly inside, so waste catches and builds up. Clay pipe is laid in short sections, and tree roots get in at the joints. In these houses the basement floor drain often runs straight to the sewer, so it is usually the first place a blocked sewer line shows up.
In post-war houses, such as those along Barrick Road and around Olga Drive, the weeping tile around the foundation is often connected to the sanitary sewer. On a dry day the drains work normally. Port Colborne averages about five days a year with 25 mm of rain or more. On those days the weeping tile sends groundwater into a sewer line that roots may already have narrowed, and the water comes back up through the floor drain. The sewer is causing the drain problem, so clearing the drain alone won't stop it happening in the next storm. The sump pumps page explains what disconnecting the weeping tile involves.
In the newer subdivisions such as Westwood Estates and Mapleview, the drains and sewer lines are plastic, and roots are rarely the problem. A slow line there is usually a blockage at a fixture or building debris left in a pipe. It can also be a backwater valve that has collected debris and hasn't been cleaned. Our backwater valve guide shows how to find the valve and check it.
How can you tell whether the cause is the sewer or the sink?
Some signs point to a problem beyond the house's own drains. The lowest drain backs up first. Several fixtures slow down at the same time. The snake brings back roots or pieces of clay. Or a line blocks again within months of being cleared. When we see any of these, we offer to run a camera down the line from the cleanout. You watch the footage on screen as the camera moves along the pipe.
The footage also shows whose pipe it is. The City of Port Colborne maintains the sanitary sewer mains. The property owner is responsible for the sewer line from the property line to the house. If the fault is on your side, we explain your options on site and on the sewer repair and backwater valves page. If the camera shows the problem at or past the property line, you have what you need to call the City. If you're a tenant or landlord working out who pays, read who is responsible for a blocked drain.
How is a drain cleared, by snake or by water jet?
We start by asking which drains are slow, how long it has been going on and what has gone down them lately. Then we find the nearest way into the pipe: the trap under the fixture, a cleanout on the stack, or the main cleanout near the floor drain. You see a written price and approve it before any work starts.
A snake (a drain cable machine) is the usual tool for a single fixture line or a root blockage. Its head cuts through the blockage, and when we pull it back we can see what it caught. A water jet sprays water at high pressure along the pipe and scours grease and sludge off the walls. It suits kitchen lines and plastic pipe that is in good shape but coated inside. On old cast iron or cracked clay we use the jet carefully, and we tell you why before deciding to use it.
When we're done, we run water through the cleared line to check that it drains. We tell you what caused the blockage and whether it is likely to come back. Work is performed by licensed plumbers (306A Certificate of Qualification). To get a written price before booking, use the quote form.
