Skip to content
Port Colborne Plumber

Sump pumps in Port Colborne

Sump pump repair and installation in Port Colborne

Port Colborne Plumber repairs, replaces and installs sump pumps and fits battery backup for power cuts. We also test the whole setup before the storm season. If the pit is filling right now, start with the safe checks below or see emergency plumber.

A pump that keeps running through storms and power cuts, tested before the season starts.

Is the pit filling and the pump not running?

Start with what is safe. If water has reached the floor around the pit, the pump cord or an outlet, do not step into it. Turn off the breaker for the basement only if you can reach the panel from dry ground. Otherwise leave everything as it is and call. If the floor is dry, look at the pump. The plug may have worked loose, the breaker or the reset button on the outlet may have tripped, or the float may be caught on the pit wall or the cord. The float is the switch that rises with the water.

If resetting the outlet or freeing the float gets the pump running, watch it through one full cycle. The water should drop and the pump should stop by itself. If it hums without pumping, does nothing at all, or the water keeps rising, stop using the washer or basement sink if either drains into the pit, and move what you can off the floor. A pump that has quit in heavy rain is an emergency call. Tell us what the water is doing and a plumber will call you back and talk you through what to do until they arrive.

Why does the pump run all the time, or click on and off?

If the pump runs without stopping after a long rain, it may just be keeping up with high groundwater. If it runs when the ground is dry, or starts and stops in short bursts, the cause is usually one of three things. The float may be set too low or sticking. The check valve may be letting the water in the discharge pipe fall back into the pit. Or the pump may be too small for the water coming in. A grinding or rattling sound usually means debris in the impeller or worn bearings.

None of these is an emergency on a dry day, so they can wait for a booked visit. They should be fixed before the next storm, though, because a pump that cycles constantly wears out its switch and motor sooner and is more likely to stop on the night you need it.

What keeps the water out when the power goes off?

The storms that fill a sump pit are often the same storms that knock out the power, and a standard pump stops the moment it loses power. A battery backup is a second pump in the same pit, on its own battery and float. It takes over when the main pump loses power or fails, and it sounds an alarm so you know it is running.

A backup needs a little looking after. Keep the battery charged and the terminals clean, and replace the battery when the manufacturer recommends. Keep the manufacturer's warranty paperwork with it. Even a house without a backup is better off with a high-water alarm, which warns you while the water is still rising and there is time to act.

Which Port Colborne houses rely on a sump pump?

Most of the newest houses do. In subdivisions such as Westwood Estates, Rosedale Estates, Mapleview and Millar's Crossing, the foundation drainage usually runs to a sump pump, often with a backwater valve on the sewer. The calls we usually get from these houses are a pump that failed in a storm or power cut, and a backwater valve nobody has looked at since the house was new. If you are not sure you have one, see does your house have a backwater valve.

Post-war houses, such as those along Barrick Road and around Olga Drive, often have their foundation weeping tile tied into the sanitary sewer. In heavy rain that groundwater goes into the sewer and adds to the risk of a backup. To fix this, the weeping tile is disconnected and sent to a new sump pit with a pump. The City of Port Colborne offers a grant to residential owners who get a water and wastewater bill. It goes towards disconnecting weeping tile, downspouts and sump pump connections from the wastewater system and towards a sewage backflow device. The grant depends on available budget, and the City has to approve the work before it starts. Changes to drains generally need a building permit too, and the City's building department will tell you whether yours does.

The oldest houses, on Tennessee Avenue and in Humberstone, usually have no sump pump at all, just a floor drain running straight to the sewer. There the main risk is sewer water coming back up, not groundwater coming in. See sewer repair and backwater valves.

How is a sump pump repaired or replaced?

The plumber asks what you have seen, then fills the pit with water to watch the pump work. They check the float, the check valve, the pit, the lid and the discharge line, both where it leaves the house and where it lets out outside. You get a written price and approve it before any part is fitted.

If the problem is the switch, the float or the check valve, a repair is usually the whole job, and we tell you so. If the motor is failing or the pump cannot keep up, we size the replacement to the water actually coming into your pit rather than copying the label on the old pump. The discharge should let out well away from the foundation and must not run into the sanitary sewer. If you want a battery backup or an alarm, it can go into the same pit at the same visit.

When should you test the pump, and how?

Environment Canada's 1981 to 2010 normals for Port Colborne give about 985 mm of precipitation a year, about 847 mm of it as rain. About five days a year bring 25 mm of rain or more, and those are the days the pump has to keep up. Test once in early fall and again before the spring thaw, rather than in the middle of a storm. The same normals show the first fall frost around October 26 and the last spring frost around April 25. Over that long winter, the part of the discharge line that runs outside can freeze, so keep the outlet clear of ice and snow. Our frozen pipes guide covers the rest of the house.

To test, pour a pail of water slowly into the pit until the float rises. The pump should start, empty the pit and stop by itself, and water should come out at the outside end. To test a battery backup, unplug the main pump and repeat. If anything does not work the way it should, ask for a written price and we will book a visit.

Our commitments

What can you count on when you call?

  • Licensed and insured

    Every plumber holds a current 306A Certificate of Qualification and is covered by liability insurance. Your home is protected on every job.

  • Every call is answered

    Day or night, a person or our receptionist answers, takes the details and a plumber calls you back.

  • Written price before work starts

    You see the number and approve it before any part is fitted. No surprises on the invoice.

  • 1-year workmanship warranty

    All labour comes backed by a one-year warranty. If a repair we made fails within the warranty period, we return and fix it at no additional labour cost.

Questions about sump pumps

What keeps a sump pump reliable through a Port Colborne storm?

How it is looked after matters more than its make. Port Colborne gets about five days a year with 25 mm of rain or more, and the newer houses in areas such as Westwood Estates and Mapleview depend on the sump pump to keep the foundation dry. Before the season, pour a pail of water into the pit and watch the pump start, empty the pit and stop. Check that the discharge pipe outside is clear and runs away from the house. A battery backup keeps the pit emptying during a power cut. Test yours this fall and read about sump pumps.

All questions

Is water somewhere it should not be?

Tell us what you see, by phone or with the form. A plumber calls you back and gives you a written price before any work starts.