Skip to content
Port Colborne Plumber

Hot water in Port Colborne

Water heater repair and installation in Port Colborne

A water heater rarely fails at a good time. When the tank is leaking or the shower has gone cold, there are one or two safe things to do first, and the rest can be worked out calmly. Port Colborne Plumber repairs, replaces and installs tank and tankless heaters, electric and gas. If water is spreading, see emergency plumber.

Leaks, cold showers and worn-out tanks, dealt with one step at a time.

Is water leaking from the heater, and what is safe to do first?

Start with two things. Find the cold water pipe that runs into the top of the tank and turn its valve clockwise until it stops, so the tank stops refilling. Then turn off the heat: for an electric heater, switch off its breaker at the panel; for a gas heater, turn the control knob to off. If water has reached an outlet, a cord or the panel, do not stand in it to reach anything. Leave it and call.

Then look at where the water is coming from. A drip from a fitting on top, from the drain valve near the floor or from the pipe on the side of the relief valve is often a repair. Water seeping out from under the tank itself usually means the lining has rusted through, and that tank cannot be fixed. With the cold valve closed, a leaking tank can usually wait until morning. With the valve left open, it should not.

If you smell gas near the heater, do not touch light switches or the heater controls. Go outside and call your gas supplier's emergency line from there. A leak that keeps spreading across the floor after the valve is shut is an emergency plumber call.

No hot water, or it runs out too fast: what is usually wrong?

On an electric tank, check the breaker first. If it has tripped, reset it once. If it trips again, leave it off, because something inside is shorting. Do not take the cover panels off a heater that still has power. No hot water at all often points to the upper element or its thermostat; water that starts hot and turns lukewarm quickly often points to the lower one. Both are ordinary parts to replace.

On a gas tank, the pilot may have gone out. Relighting it by following the instructions on the label is fine to try once. If it goes out again, stop there. The cause may be a worn flame sensor or a venting problem that is shutting the burner down on purpose, and a technician needs to look at it.

Rumbling or popping from the tank is usually a layer of sediment on the bottom, more common in older tanks that have never been flushed. Rust-coloured water from the hot taps only points to the tank. A rotten-egg smell in the hot water alone is usually a reaction at the anode rod, and it can often be dealt with without replacing the heater.

Has the heater been under water after a basement backup?

Port Colborne gets about five days a year with 25 mm of rain or more, and in older houses around Tennessee Avenue and Humberstone the basement floor drain often runs straight to the sewer. In post-war houses near Barrick Road, the weeping tile may be tied into the sanitary line. Either way, a heavy downpour can put water around the base of the heater.

If the burner or gas controls of a gas heater have been under water, do not relight it. Wet gas controls are not safe to reuse and are replaced, not dried out. For an electric heater, keep the breaker off until it has been checked. If backups keep happening, the cause is in the sewer line, not the heater, and sewer repair and backwater valves explains the City grant towards a backflow device.

Is the water at the tap too hot, or never warm enough?

Ontario's Building Code (Part 7, Article 7.2.10.7.) limits water coming out of a shower head or into a bathtub to 49 °C. The tank itself is often kept hotter than that, and a mixing valve at the heater or the shower's own valve brings the temperature down at the outlet. If the bath water stings, or someone in the house is very young or elderly, sort this out before anything else on this list.

You can check it yourself: run the tub hot for a minute and hold a kitchen thermometer in the stream. If it reads above the limit, ask about it when you book. The plumber can adjust or fit a mixing valve and confirm the reading at the tub. If the water never gets warm enough, the cause is often a thermostat or element, or a mixing valve set too low, rather than a heater that is too small.

Repair or replace: how do you decide?

Start with the label on the side of the tank. It shows the model and a serial number that usually encodes the year it was made, and the manufacturer warranty on the tank and parts often runs longer than people expect. Check it, and any paperwork from the original installation, before paying for a part that may still be covered.

A leak from the tank body means replacement. A failed element, thermostat, flame sensor or valve on a tank that is otherwise sound is usually worth repairing. Between those two, it depends on the age of the tank and what the repair involves, and you will be given both options in writing so you can choose.

How does a replacement or new installation go?

The new heater is sized to the household: how many people, how many bathrooms and how hot water is used, not just what the old label said. Tank or tankless, electric or gas, the choice also depends on the house. Older houses may vent a gas heater through a chimney that needs a liner or a different vent, and a tankless unit needs a gas line large enough to feed it. Some jobs need a building permit, and the City's building department says which.

Work is performed by licensed plumbers (306A Certificate of Qualification). Gas work is performed by TSSA-certified gas technicians, as Ontario Regulation 212/01 requires for fuel-fired appliances. You see the price in writing and approve it before the old tank is disconnected. To start, describe your heater on the quote page.

Our commitments

What can you count on when you call?

  • Licensed and insured

    Every plumber holds a current 306A Certificate of Qualification and is covered by liability insurance. Your home is protected on every job.

  • Every call is answered

    Day or night, a person or our receptionist answers, takes the details and a plumber calls you back.

  • Written price before work starts

    You see the number and approve it before any part is fitted. No surprises on the invoice.

  • 1-year workmanship warranty

    All labour comes backed by a one-year warranty. If a repair we made fails within the warranty period, we return and fix it at no additional labour cost.

Questions about water heaters

Who can install or service a gas water heater in Port Colborne?

In Ontario, fuel-fired appliances such as gas water heaters must be installed and serviced by a registered contractor using qualified gas technicians, under Ontario Regulation 212/01 (Gaseous Fuels). That covers replacing the heater, moving it and working on the gas line or venting. Gas work is performed by TSSA-certified gas technicians. If you smell gas near the heater, leave the house first and call your gas utility from outside. For anything else, such as no hot water or a leak at the base, note what the heater is doing and read about water heaters.

All questions

Is water somewhere it should not be?

Tell us what you see, by phone or with the form. A plumber calls you back and gives you a written price before any work starts.