Skip to content
Port Colborne Plumber

Port Colborne plumbing repairs

Plumbing repairs in Port Colborne

A pipe leaking into the basement, a toilet that keeps running, an outdoor tap split by frost or an old galvanized line that has lost its pressure. Port Colborne Plumber finds where the water is getting out, fixes it and tells you plainly what can wait. If you cannot stop the water, see emergency plumber.

Leaks, taps, toilets and old pipe, dealt with in the right order.

Water is coming from a pipe right now: what is safe to do first?

Close the main shut-off valve. In most Port Colborne houses it is where the water line comes through the basement wall, near the meter. Turn it clockwise until it stops. Then open a cold tap on the lowest floor so the pipes drain. If water is reaching a light fitting, an outlet or the electrical panel, do not touch it. Switch that circuit off at the breaker only if you can reach the panel from a dry floor. If you can't, stay clear.

Once the water stops, there is time to find the source. Most household leaks come from a few places: a pinhole in the copper line of a post-war house around Barrick Road or Olga Drive, a threaded joint rusted through on galvanized pipe in an older home, or a supply hose behind the washer or under a sink. In winter, a pipe split by frost is the other usual cause. If the main valve will not close, or the leak is on the street side of it, call an emergency plumber.

Can a running toilet or a dripping tap wait?

Usually, yes. A toilet that refills by itself every few minutes is wasting water, but it is not damaging the house. You can close the small valve behind it until someone comes to fix it. A dripping faucet is the same. The cause is normally a worn cartridge, washer or seal, and the repair is short.

Water you cannot see should not wait. Watch for a toilet that rocks on its base, a stain spreading on the ceiling under a bathroom, or a vanity floor that stays soft. Any of these means water has been escaping for some time. Close the valve for that fixture, put a towel down and book a visit.

Why does the outdoor tap leak when the weather turns?

Port Colborne has a long frost season. Environment Canada's 1981-2010 climate normals for the local station show about 121 days a year at or below 0 °C. The first fall frost comes around October 26 and the last spring frost around April 25. An outdoor tap that still has water in it during those months can split inside the wall. Often the leak only shows in spring, the first time the hose is turned on.

A few minutes in the fall prevents most of this. Close the indoor valve that feeds the outdoor tap, open the outdoor tap so it drains, and take the hose off. If the tap drips into the basement the first time you use it in spring, close that indoor valve again and leave it closed until the tap is repaired. Our guide on keeping pipes from freezing covers the rest of the house.

Is the old pipe in your house galvanized, lead or Kitec?

Houses built before 1945, such as the ones on Tennessee Avenue and in the former Village of Humberstone, often started with galvanized steel or lead water lines. Galvanized pipe rusts from the inside. Pressure fades slowly, water can run brown after sitting overnight, and the threaded joints are where leaks usually start.

You can check for lead yourself. Look at the pipe where the water line enters the basement, before the meter. Lead is dull grey and soft enough that a coin scratches it shiny, and a magnet will not stick to it. Kitec is a plastic pipe, usually orange or blue, joined with brass fittings that can corrode. It is easy to recognize at the water heater or under a sink.

Finding any of these does not mean everything has to come out at once. A leaking section of galvanized pipe can be replaced and the rest planned for later. A lead service line is worth planning for soon, and the next section explains who owns which part of it.

Which part of the water line is yours, and is there help with the cost?

The City of Port Colborne operates the system that brings water to your street. The City is responsible for the lines from the main to the property line, and the owner is responsible from the property line to the house. The sewer line is split the same way.

The City offers grants to owners of existing homes towards replacing the private water line and sewer line, and notes that many older lines may contain lead. Ask the City about the current terms before any work starts. Ontario sets the drinking water limit for lead at 0.010 milligrams per litre. Until a lead line is replaced, run the cold tap until it feels cold before you drink, and cook with cold water.

Replacing a service line means digging. In Ontario a locate has to be requested through Ontario Dig Authority before anyone digs. Public locates do not mark private lines such as your own sewer. New plumbing and changes to drains generally need a building permit too, and the City's building department confirms whether a particular job does. For the sewer side, see sewer repair and backwater valves.

How does a repair visit go?

We start by asking what you have seen and where the shut-off is. Then we look at the pipe on both sides of the problem as well as the drip itself. If a repair will hold, we say so. If the pipe behind it is the real problem, we show you why and give you both options.

You get the price in writing and approve it before we begin. Work is performed by licensed plumbers (306A Certificate of Qualification). In Ontario, plumbing is governed by Part 7 of the Building Code, and if your job needs a permit we tell you before the work is scheduled. To get started, request a quote or look over our other services.

Our commitments

What can you count on when you call?

  • Licensed and insured

    Every plumber holds a current 306A Certificate of Qualification and is covered by liability insurance. Your home is protected on every job.

  • Every call is answered

    Day or night, a person or our receptionist answers, takes the details and a plumber calls you back.

  • Written price before work starts

    You see the number and approve it before any part is fitted. No surprises on the invoice.

  • 1-year workmanship warranty

    All labour comes backed by a one-year warranty. If a repair we made fails within the warranty period, we return and fix it at no additional labour cost.

Questions about repairs

Could my older Port Colborne house have a lead water line?

It could. Port Colborne's water is drawn from the Welland Canal, treated by Niagara Region and delivered by the City, and the City notes that many older private water lines may contain lead. Ontario's drinking water standard for lead is 0.010 milligrams per litre. Look at the pipe where it comes through the basement wall, before the meter. Lead is dull grey and soft enough to scratch shiny with a key, and a magnet will not stick to it. If that is what you see, ask the City about its private service line grant, then read about replacing your side of the line under plumbing repairs.

When does plumbing work on a Port Colborne house need a building permit?

Under Ontario's Building Code Act, 1992, installing, extending or materially altering or repairing plumbing generally needs a permit, so new fixtures and changes to drains usually do. The work must meet Part 7 of Ontario's Building Code, Ontario Regulation 163/24. Plumbing is a compulsory trade in Ontario: the person doing it must hold a Certificate of Qualification or a provisional certificate, or be a registered apprentice, and appear on the Skilled Trades Ontario Public Register. Work is performed by licensed plumbers (306A Certificate of Qualification). Before work that changes your drains, ask the City of Port Colborne building department whether a permit applies, and see plumbing repairs.

All questions

Is water somewhere it should not be?

Tell us what you see, by phone or with the form. A plumber calls you back and gives you a written price before any work starts.